|
| Articles |
|
|
RF and Microwave Connectors - Part 1 |
RF and Microwave Connectors Part - 1
Contents
Introduction
... |
|
Transmitting Signals From Radio Frequency Antennas Using RF Antenna Cable |
Television channels are obtained because of the Radio Frequency signals. If one wants to have more channels, it means they n... |
|
Circular MT Optical Cable Assemblies |
High-density Circular MT Optical Cable Assemblies are designed for critical, high-reliability applications Circular MT ConnectorCircular MT Connector and Receptacle1-by-3 Circular MT Connector and AdapterCircular MT ReceptacleMolex’s rugged, high-density circ... |
|
Article on Fiber Optic Ribbon Cable |
Unsurpassed reliability
Gore proprietary ePTFE firm-tube buffer technology provides exceptional reliability. Gore ribbon cables can perform more than 1,000 flex cycles on a 0.5 in. bend radius using standard gang connectors and splices.
This graph demonstrates how Gore's fiber o... |
|
Surpassing RG Cable |
Gore's standard offering includes several cables with performance surpassing those of similar RG construction. Gore's advanced cables offer up to 49% lower attenuation or outer diameter reductions of as much as 47% while preserving the highest electrical integrity. As a result, these cables will ... |
|
Ways to Optimize the Performance of a Difference Amplifier |
There are times when a small signal needs to be measured in the presence of a large common-mode signal. Traditional instrumentation amplifiers (in-amps) that have two op amp or three op amp internal configurations are commonly used in these applications. Although in-amps have good common-mode rej... |
|
Co-axial Cable Measurements |
Co-axial
Cable Insertion and Return Loss Measurement
... |
|
Previous | Next
|
|
